Questions tagged [propagation]

Questions about RF propagation including measurements, beacons, modes (ionospheric, tropospheric, ground wave), etc.

RF propagation is the behavior of radio waves when they are transmitted. As a form of electromagnetic radiation radio waves are affected by the phenomena of reflection, refraction, diffraction, absorption, polarization and scattering.

RF propagation is affected by the daily changes of water vapor in the troposphere, ionization in the upper atmosphere due to the Sun, the frequency of the emission, the path over ground of the transmission. If the path is over-the-horizon path aided by refraction in the ionosphere, it will be influenced by factors that include sporadic-E, spread-F, solar flares, geomagnetic storms, ionospheric layer tilts, and solar proton events.

Propagation Modes

Surface modes (groundwave) — LF (between 30 and 3,000 kHz) have the property of following the curvature of the earth via groundwave propagation. In this mode the radio wave propagates by interacting with the semi-conductive surface of the earth. The wave "clings" to the surface and thus follows the curvature of the earth. Vertical polarization is used to alleviate short circuiting the electric field through the conductivity of the ground. Since the ground is not a perfect electrical conductor, ground waves are attenuated rapidly as they follow the earth’s surface. Attenuation is proportional to the frequency making this mode mainly useful for LF and VLF frequencies.

Direct modes (line-of-sight) — Line-of-sight is the direct propagation of radio waves between antennas that are visible to each other. This is probably the most common of the radio propagation modes at VHF and higher frequencies.

Ionospheric modes (skywave) — Skywave propagation, also referred to as skip, is any of the modes that rely on refraction of radio waves in the ionosphere, which is made up of ionized layers in the upper atmosphere. F2-layer is the most important ionospheric layer for long-distance, multiple-hop HF propagation, though F1, E, and D-layers can also play significant roles.

The D-layer, when present during sunlight periods, causes significant amount of signal loss, as does the E-layer whose maximum usable frequency can rise to 4 MHz and above and thus block higher frequency signals from reaching the F2-layer. The layers, or more appropriately "regions", are directly affected by the sun on a daily cycle, a seasonal cycle and the 11-year sunspot cycle and determine the utility of these modes.

  • Meteor scattering
  • Auroral backscatter
  • Sporadic-E propagation

Tropospheric modes

  • Tropospheric scattering
  • Tropospheric ducting
  • Tropospheric delay
  • Rain scattering
  • Lightning scattering

Other effects

  • Diffraction
  • Absorption
147 questions
9
votes
1 answer

Around the world propagation?

Is it possible to transmit a signal around the world and receive it? Has anyone done it, and how? If not, how could this be accomplished? Assuming a complete path around the world, what kind of time delay should one expect on their transmission?
Adam Davis
  • 12,125
  • 2
  • 47
  • 107
9
votes
1 answer

What are the general effects of a geomagnetic storm on propagation?

Per NOAA/NWS Space Weather Prediction Center, "SWPC Forecasters are anticipating G3 (Strong) Geomagnetic Storm conditions to occur January 9 and 10." What does that mean, very generally, for amateur radio communications? Does it depend on the type…
Adam Davis
  • 12,125
  • 2
  • 47
  • 107
8
votes
1 answer

Ground influence on 434 MHz radio signal

I have read in a paper that ground acts as reflector for radio signals in 434 MHz band. Why is that the case?
Nexy_sm
  • 241
  • 1
  • 3
5
votes
3 answers

If EM waves require no medium, why can't I get service at all times?

I have taken two years of high school physics and am very interested in RF communication. I know that electromagnetic waves do not necessitate a medium in order to propagate. Thus, shouldn't I be able to send/receive RF signals even when the signal…
MikeE
  • 53
  • 4
4
votes
1 answer

No stations on MW band at daytime

I have a portable radio which serves for FM / MW / SW bands. At nights I can listen to 4-6 international channels from different countries on MW. However, I am unable to tune them at daytime. Is it about my location as a result of earth's spin or…
Karel Capek
  • 145
  • 4
4
votes
2 answers

What is "Meter" referencing in "60-Meter Band"?

I know that there are various bands referenced in meters (or cm). My question refers to what exactly the word "meter" is referring to when identifying the 5MHz band? I know that the 60-meter band is 5MHz, and considering that communications on that…
4
votes
1 answer

AM vs SSB weak signal

I know single sideband is much better than FM for weak signal receiving. I know that SSB is just like AM, but with the unneeded parts removed. For weak signal propagation, like EME and aurora, would reception on AM or SSB be better?
Skyler 440
  • 7,600
  • 7
  • 49
  • 89
3
votes
1 answer

What causes the audio distortion when working aurora?

I recently watched a video of someone making an auroral voice contact, and the received audio had a distinctively raspy and disembodied sound to it. Some CW was audible in the background and it had the same sound to it. I understand that this is…
Flup
  • 163
  • 6
3
votes
2 answers

Acceptable link margin for voice communication in uhf band

I want to understand the theory behind how link margin or fade margin is decided? If I have to have a point to point UHF voice communication link from ground to aircraft, for example, with a reliability of 95%, how is the link margin decided? What…
user5349
  • 251
  • 2
  • 6
3
votes
3 answers

Given the classical top down view, what does a bottom up view of RF waves look like?

Quote from Wikipedia, Photons: "Nevertheless, all semiclassical theories were refuted definitively in the 1970s and 1980s by photon-correlation experiments. Hence, Einstein's hypothesis that quantization is a property of light itself is considered…
Cecil - W5DXP
  • 1,656
  • 6
  • 8
2
votes
1 answer

Find RF transmission distance

I guess my question is as follows: if I find FSPL (there will be no buildings or anything blocking/diffracting), can I figure out how far the signal can be transmitted if the receiver gain, loss and sensitivity as well as the transmission power and…
dylnmc
  • 123
  • 5
2
votes
1 answer

Propagation Analysis with WSPR / RBN

I would like to analyze data from the Weak Signal Propagation Reporter (WSPR) and/or the Reverse Beacon Network to understand the propagation mode(s) of the recent welcome spate of CW and SSB contacts between North America and Europe on the 10 meter…
Brian K1LI
  • 7,838
  • 10
  • 33
1
vote
5 answers

How to learn about the physics behind propagation?

What are good sources for information about the propagation of RF that details the equations behind the curtain? I've been able to find some simple stuff on wikipedia but nothing fancy that I'm sure exists. There's also a lack of clarity on what…
1
vote
2 answers

How is the 10 m band performing now in January 2014?

I bought a 10m radio on eBay back in 2007 during the solar minimum when 10m propagation was nothing to write home about. I verified that the radio worked at that time, though it didn't seem to work very well. And I wasn't sure if it was the…
1
vote
0 answers

To decide coherent time and fade duration from measured received signal spectrum and relate them to channel modeling

This question was asked in Electrical Engineering 2 days ago but hasn't received very informative responses. https://electronics.stackexchange.com/questions/387255/decide-coherent-time-and-fade-duration-through-empirical-studies-on-the-channel I.…
luw
  • 57
  • 1
  • 7
1
2