recently assembled an Ender 3 V2 but I am having trouble printing ANYTHING in general, something always messes up.
When printing the bottom layer a print, after the first layer (which sticks well to my glass bed) tiny fuzzy bumps start sticking out of the surface of the print. I can "fix it" by setting the z offset to be higher up but it is not a consistent fix as it sometimes returns. If i leave the fuzz and let the bottom layer finish, it will end up like the last picture, where there is a layer of blob sticking out from the base layer.
I am using PLA+ at 200 degrees and 55 bed temp. I have tried multiple prints speeds of 60, 80 and 100 and the problem stays.
THANK YOU FOR YOUR HELP!
